|
Working
principle
The casing
contains a special high elasticity and resistance hose, which is
flanged at both ends (connections). The flanges are connected to
the suction and discharge lines of the system. Within the casing
is a rotor with two rollers at opposite points about its centre
line and mounted on a shaft with bearings. As a result of the
rotor pivoting, the hose is totally compressed by the rollers and
the product within the hose is pushed forward. The sucking action
comes as restores its original cylindrical form after
compression. The worn surface must be lubricated with siliconic
grease.
Are available
even with fiber reinforced constructions, in a lot of compounds to
choose according to service conditions.
Easy to clean
and sterilize.
The pumped
fluid doesn't contact any mechanical part.
Simply
adjustable.
Few wearing
part.
Easy
maintenance, low cost, short down time.
Lubrication
with siliconic grease. |
Metering for capacities up to 1000 L/H and discharge pressure up to 2 bar
Pressure for capacities up to 20.000 L/H and discharge pressure up to 10 bar
Italian factory producing :
peristaltic pump for muds abrasives, corrosives, alimentary. Muds, abrasive and
alimentary.
Expecially tested on mud, abrasive, alimentary and
corrosive products.
No wearing parts:
the worn surface must be
lubricated with siliconic grease.
|
